Centos7 配置静态IP_centos7的ifcfg-eth0显示ip是00:0c:29:b7:45:69-优快云博客

本文链接：https://blog.youkuaiyun.com/yijunwanghaha/article/details/71066322

本文介绍如何在 CentOS 系统中为 eth0 网络接口配置静态 IP 地址，并通过重启网络服务使配置生效。

摘要生成于 C知道，由 DeepSeek-R1 满血版支持，前往体验 >

  1、编辑 ifcfg-eth0 文件。 

 vi /etc/sysconfig/network-scripts/ifcfg-eth0

  2、修改如下内容 

BOOTPROTO="static" #dhcp改为static   
ONBOOT="yes" #开机启用本配置  
IPADDR=192.168.163.100 #静态IP   
NETMASK=255.255.255.0 #子网掩码

  3、修改后效果 

HWADDR="00:15:5D:07:F1:02"  
TYPE="Ethernet"  
BOOTPROTO="static" #dhcp改为static   
DEFROUTE="yes"  
PEERDNS="yes"  
PEERROUTES="yes"  
IPV4_FAILURE_FATAL="no"  
IPV6INIT="yes"  
IPV6_AUTOCONF="yes"  
IPV6_DEFROUTE="yes"  
IPV6_PEERDNS="yes"  
IPV6_PEERROUTES="yes"  
IPV6_FAILURE_FATAL="no"  
NAME="eth0"  
UUID="bb3a302d-dc46-461a-881e-d46cafd0eb71"  
ONBOOT="yes" #开机启用本配置  
IPADDR=192.168.163.100 #静态IP  
NETMASK=255.255.255.0 #子网掩码

  4、重启下网络服务 

service network restart

  5、查看改动后的效果。 

[root@localhost ~]# ifconfig
eth0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST>  mtu 1500
        inet 192.168.163.100  netmask 255.255.255.0  broadcast 192.168.163.255
        ether 00:0c:29:33:be:b0  txqueuelen 1000  (Ethernet)
        RX packets 46  bytes 5175 (5.0 KiB)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 47  bytes 7202 (7.0 KiB)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0

lo: flags=73<UP,LOOPBACK,RUNNING>  mtu 65536
        inet 127.0.0.1  netmask 255.0.0.0
        inet6 ::1  prefixlen 128  scopeid 0x10<host>
        loop  txqueuelen 0  (Local Loopback)
        RX packets 0  bytes 0 (0.0 B)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 0  bytes 0 (0.0 B)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0