Mac OS X Eclipse CDT Missing Binaries

最新推荐文章于 2026-01-08 21:38:09 发布

转载最新推荐文章于 2026-01-08 21:38:09 发布 · 1.2k 阅读

文章标签：

#eclipse #os #menu #properties #gcc #up

C/C++ 专栏收录该内容

105 篇文章

订阅专栏

文章详细介绍了如何解决Eclipse安装64位Mach-O解析器后无法正常运行项目的bug，包括确认Mach-O64解析器设置及尝试重新配置的方法。

转载自：http://thexploit.com/tools/os-x-10-6-64-bit-eclipse-cdt-missing-binaries/

I was hoping to do some code samples in C from the book tonight but unfortunately I ran into a snag. After installing Eclipse CDT to Eclipse Helios I thought I was good to go. For some reason though, after explicitly building my project with ⌘B no Binaries menu would shows up in Eclipse

Without no Binaries menu, that means that Eclipse can’t run your project and spits out an error.

I made sure I was choosing the MacOSX GCC but binaries still wouldn’t show up. I searched around for a while and others had similar problems when Eclipse didn’t have support for a 64 bit Mach-O parser. However looking at my project properties Eclipse shows a Mach-O 64 Parser.

I was stumped at this point since all the suggestions mentioned to make sure your Mach-O Parser was checked or add “-arch i386″.

I really wanted to compile in 64 bit so I played around a little more and figured out that if your Binaries menu is missing from Eclipse, try checking and unchecking the Mach-O 64 Parser then click OK. After doing that – success! I can now see the Binaries menu and Eclipse doesn’t give me “Launch Failed. Binary not found.” error.