redis 远程连接出错的解决办法

最新推荐文章于 2025-06-12 08:15:43 发布

转载最新推荐文章于 2025-06-12 08:15:43 发布 · 219 阅读

1 ·

CC 4.0 BY-SA版权

原文链接：http://www.cnblogs.com/musings/p/8072591.html

文章标签：

#数据库 #php #网络

本文介绍了如何配置Redis防火墙端口、关闭protected mode，并通过Predis实现PHP与Redis的连接。首先，需开放Redis默认端口6379；其次，关闭protected mode以允许外部连接；最后，使用Predis进行PHP编程。

1. 配置防火墙端口

redis系统的默认端口是6379端口。

# 打开端口
$ firewall-cmd --zone=public --add-port=6379/tcp --permanent
# 命令含义：
# --zone #作用域
# --add-port=80/tcp  #添加端口，格式为：端口/通讯协议
# --permanent   #永久生效，没有此参数重启后失效

# 重启防火墙
$ firewall-cmd --reload

2. 关闭Redis的protected mode

# 关闭protected-mode
127.0.0.1:6379> CONFIG SET protected-mode no

# 如果不关闭，则会出现这个错误：
# Fatal error: Uncaught exception 'Predis\Response\ServerException' with message 'DENIED Redis is running in protected mode because protected mode is enabled, no bind address was specified, no authentication password is requested to clients. In this mode connections are only accepted from the loopback interface. If you want to connect from external computers to Redis you may adopt one of the following solutions: 1) Just disable protected mode sending the command 'CONFIG SET protected-mode no' from the loopback interface by connecting to Redis from the same host the server is running, however MAKE SURE Redis is not publicly accessible from internet if you do so. Use CONFIG REWRITE to make this change permanent. 2) Alternatively you can just disable the protected mode by editing the Redis configuration file, and setting the protected mode option to 'no', and then restarting the server. 3) If you started the server manually just for testing, restart it with the '--protected-mode no' option. 4) Setup a bind address or an authen in D:\www\redis\predis\Client.php on line 370

3. 下载Predis

Predis是Redis官方推荐的PHP连接工具。

<?php
require 'predis/Autoloader.php';
Predis\Autoloader::register();

$server = array(
    'host'     => '192.168.23.140',
    'port'     => 6379
);

$client = new Predis\Client($server);
$client->set('foo', 'bar');
$value = $client->get('foo');
echo $value;