JVM terminated. Exit code=8096

最新推荐文章于 2021-03-13 11:15:40 发布

weixin_30278311

最新推荐文章于 2021-03-13 11:15:40 发布

阅读量289

点赞数

CC 4.0 BY-SA版权

文章标签： java 开发工具

原文链接：http://www.cnblogs.com/cupsuccess/p/3934250.html

本文提供了解决在Rational Application Developer v7中遇到的使用Java2D系统导致崩溃的问题的方法。包括升级到最新版本、禁用Direct3D的建议以及解决在Windows 64位平台上的Java核心错误的步骤。

摘要生成于 C知道，由 DeepSeek-R1 满血版支持，前往体验 >

http://www-01.ibm.com/support/docview.wss?uid=swg21303648

Technote (troubleshooting)

Problem(Abstract)

Attempts to open a .jsp page using IBM Rational Application Developer for WebSphere Software v7 crashes with the error "JVM terminated. Exit code=8096".

Symptom

Rational Application Developer v7 crashes with the following JVM terminated error message:

Cause

This behavior might be caused by the incorrect rendering on a small set of Microsoft Windows computers with bad DirectDraw or Direct3D drivers. Hence, the use of DirectDraw or Direct3D drivers by Java 2D system in Rational Application Developer v7 can cause the crash.

Note: This error is not always caused as the result of DirectDraw or Direct3D drivers.

Resolving the problem

Consider upgrading to the latest Rational Application Developer v7.0.x release before carrying out the option of disabling Direct3D.

In the case of Rational Application Developer v8.0 or later versions on a Windows 64-bit platform experiencing this JVM error, consult the technote "Internet Explorer v9 or higher is required if the product was installed using the 64-bit Bit Mode option on a 64-bit system". This addresses the jscript.dll error showing in a javacore.

You can also try clearing the temp folder as described in the following forum post. The workaround presented is for Lotus Notes, but may also apply in this case.

WORKAROUND:
To turn off the use of Direct3D in Rational Application Developer v7, you can use the following Java parameter option:

-Dsun.java2d.d3d=false

If that does not solve the problems, try removing DirectDraw or Direct3D completely using:

-Dsun.java2d.noddraw=true

Note: You can put this Java parameter option inside the eclipse.ini in the directory <RADv7_install_dir>\SDP70\

Open a service request with IBM support if none of the suggestions above have helped to resolve the problem.