monitor command not supported by this target

在eclipse中调试程序时遇到'monitor command not supported by this target'错误,该问题困扰多日且网上鲜有解决方案。通过在终端以root用户运行./JLinkGDBServer,然后重启eclipse,可以解决问题。确保在调试前正确运行./JLinkGDBServer是关键。

摘要生成于 C知道 ,由 DeepSeek-R1 满血版支持, 前往体验 >

eclipse下调试程序,有时出现monitor command not supported by this target

这尼玛啥玩意,折腾几天也没搞懂,网上也没找到解决办法。

后来,重新在终端运行./JLinkGDBServer,重新打开eclipse,然后···就没然后了···

所以eclipse调试前,一定要保证运行 ./JLinkGDBService啊

【特别说明     运行./JLinkGDBServer要以root用户运行

### CCS Debugger Usage and Troubleshooting When working with the XDS100v2 hardware unit alongside a version of Code Composer Studio (CCS) that does not officially support it, compatibility issues may arise. The software might recognize but not fully utilize all features provided by this hardware unit due to lack of proper driver or firmware updates[^1]. For ensuring optimal performance when using unsupported versions of hardware units like XDS100v2 with CCS: - Verify if there are any available patches from Texas Instruments for extending support. - Consider upgrading to a newer release of CCS which includes enhanced device support. For configuring debugging interfaces such as UART settings required during development processes involving embedded systems programmed through CCS, adjustments can be made via configuration tools within your project setup environment. Specifically, one should configure the desired console index utilizing the Kconfig utility by modifying `CONFIG_CONS_INDEX`. This change ensures appropriate UART-related pin multiplexing configurations inside functions like `set_uart_mux_conf()` found in files such as `board.c`[^2]. In scenarios where process monitoring is necessary while running applications developed under CCS on target devices, commands similar to executing `./prw.sh stat` allow users to monitor background tasks including those initiated by debuggers connected over JTAG/SWD interfaces used commonly between CCS and evaluation boards equipped with processors supported by TI's ecosystem[^3]. ```bash # Example command to check procwatcher status ./prw.sh stat ```
评论
添加红包

请填写红包祝福语或标题

红包个数最小为10个

红包金额最低5元

当前余额3.43前往充值 >
需支付:10.00
成就一亿技术人!
领取后你会自动成为博主和红包主的粉丝 规则
hope_wisdom
发出的红包
实付
使用余额支付
点击重新获取
扫码支付
钱包余额 0

抵扣说明:

1.余额是钱包充值的虚拟货币,按照1:1的比例进行支付金额的抵扣。
2.余额无法直接购买下载,可以购买VIP、付费专栏及课程。

余额充值