Set Quuppa Locators to Fixed IP address (with DHCP server)_quuppa定位设置固定ip-优快云博客

本文链接：https://blog.youkuaiyun.com/wanghao_sh/article/details/121472856

这篇博客介绍了如何将Quuppa定位器从默认的动态IP地址设置为固定的IP地址。首先，需要配置一个指向QPE服务器IP的域名。然后，更新QPE至7.0及以上版本并升级定位器固件。接着，重置定位器到出厂设置。最后，通过QPE界面设定每个定位器的固定IP地址。整个过程涉及网络配置、软件升级和设备管理。

摘要生成于 C知道，由 DeepSeek-R1 满血版支持，前往体验 >

Set Quuppa Locators to Fixed IP address

By default, the Quuppa locators use dynamic IP address assigned by DHCP server.

But in some cases, it is required to set them to fixed IP address for some reasons.

Followed are the instructions of set Quuppa locators to Fixed IP address.

0. Configure a domain

All setting operation is runs by a browser, you’d better configure a domain qpe which is pointed to the IP address of QPE server.

If are using Linux or macOS, you can configure the domain by edit the hosts file.

sudo vi /etc/hosts

Add a line like:

192.168.100.6	qpe

Save and exit.

1. Update QPE

Only QPE 7.0 or above version supports fixed IP address feature. If your project has a QPE 7.0 or above version, you should upgrade the QPE and firmware to the latest.

1.1. Upgrade QPE

Copy qpe-*.war to %Tomcat%/webapps/.
restart QPE service.
Open browser (Chrome, Edge are preferred) and visit http://qpe:8080/qpe/ to test whether the QPE upgraded successfully.

1.2. Upgrade Firmware of Locators

Open browser and visit
http://qpe:8080/qpe/upgradeAllFW

2. Reset locators

Open browser and visit the URL like: http://qpe:8080/qpe/setLocatorIP?mode=reset&locator=a4da22efe186,a4da22efcc9e&humanReadable=true.

The parameter locator is a string made of locator IDs joined with “,”.

If the command runs OK, the code in the responded JSON string should be 0.

{
	"code": 0,
	"command": "http://qpe:8080/qpe/setLocatorIP?mode=reset&locator=a4da22efe186,a4da22efcc9e&humanReadable=true",
	"message": "2 Locator(s) commanded to factory settings",
	"responseTS": 1637560930351,
	"status": "Ok",
	"version": "1.0"
}