vmware下为linux挂载(mount) u盘(usb device)

最新推荐文章于 2025-06-26 16:26:38 发布

转载最新推荐文章于 2025-06-26 16:26:38 发布 · 3.8k 阅读

文章标签：

#vmware #linux #system #file #command #path

C++ 学习笔记专栏收录该内容

26 篇文章

订阅专栏

本文档详细介绍了如何在Linux主机上将USB设备挂载到VMware Workstation虚拟机中，包括确认USB设备未被主机使用、创建挂载点、进行挂载操作等步骤，并特别说明了对于连接通过USB端口的MultiClamp设备的有效配置。

摘要生成于 C知道，由 DeepSeek-R1 满血版支持，前往体验 >

Prequisite:

1) Make sure your host O/S does not have it mounted or loaded.

2) use fdisk -l look The usb device was mounted or not.

3)mkdir /mnt/usb

4)mount /dev/sd(a,b,c)(1,2,3) /mnt/usb

note: Make sure /proc/bus/usb is mounted as filesystem type usbfs.
# mount -t usbfs none /proc/bus/usb

notes1: On Linux hosts, VMware Workstation uses the USB device file system to connect to USB devices. In most Linux systems that support USB, the USB device file system is at
/proc/bus/usb.
If your host operating system uses a different path to the USB device file system, run the following command as root to mount the file system to the expected location:
mount -t usbfs none /proc/bus/usb

notes2: In VMware, Edit the virtual machine settings-> Add a usb controller-> Rebooting the virtual machine-> Enable(load) the usb device in "VM"-"Removable Devices"-"USB deivces"

This will be extremely useful since the MultiClamp is connected through usb port and we can use some portable hard drive with the virtual machine to pass the data to the host machine