Solaris 10 改ip参考文档之一

How to Change hostname and/or IP Address Without Running sys-unconfig - Solaris 10 and below [Video] (Doc ID 1005908.1)

本文不做翻译，全文转载:

Applies to:

Solaris SPARC Operating System - Version 8.0 to 10 1/13 U11 [Release 8.0 to 10.0]
All Platforms
Note, this document applies to Solaris 10 and below only. For Solaris 11, please instead refer to the Product Guides in relation to "ipadm" command.

Goal

The purpose of this document is to explain how to change a system's hostname and/or IP address without running the sys-unconfig command since this will restore the system's configuration to an "as-manufactured" state, ready to be reconfigured again. See the sys-unconfig(1M) man page for more information regarding the changes which this command makes to the system.

Solution

Video - Using the sysunconfig command (10:00)

 

Note: The procedures shown in the document should not be used on a system which is hosting a naming service, e.g., NIS or NIS+. Furthermore, any changes made only affect the local host and it may be necessary to update naming services to reflect these changes.

References to appropriate Solaris[TM] reference manual pages are given in square brackets in what follows. These may be viewed using the man(1) command with the following syntax.

# /usr/bin/man -s<section> <name>   

where <section> should be replaced by the section of the manual and <name> should be replaced by the name of the man page. For example,

# /usr/bin/man -s4 hosts 

# /usr/bin/man -s7D ticotsord

Steps to Follow
Please follow the steps listed under each heading to accomplish the desired effect.

Changing the Hostname

1. Edit the following files and globally replace the old name with the new name as necessary.

• /etc/inet/hosts [hosts(4)]

• /etc/nodename [nodename(4)]

• /etc/hostname.<interface>

  where <interface> is replaced by the name of the primary interface for the system, e.g., "hme0". It is possible that this file contains an IP address instead of a name, if this is the case you may leave this file as it is unless you are also changing IP addresses (see below).

2. If you are running a version of Solaris[TM] prior to 10 you should also edit the following files.

• /etc/net/ticlts/hosts [ticlts(7D)]

• etc/net/ticots/hosts [ticots(7D)]

• /etc/net/ticotsord/hosts [ticotsord(7D)]

3. For Versions of Solaris[TM] later than 7, check the /etc/inet/ipnodes file [ipnodes(4)] and edit it appropriately.

4. Reboot the system.

Changing IP Addresses

1. Edit the /etc/inet/hosts file as necessary.

2. Check each interface configuration file and edit it as appropriate. These files may be listed using the find(1) command as follows.

  # /usr/bin/find /etc -name hostname.*

     Note : Each file may contain a name rather that an IP address and may be left alone if this is the case.

2. If you are running a version of Solaris[TM] prior to 10 you should also edit the following files.

• /etc/net/ticlts/hosts

• etc/net/ticots/hosts

• /etc/net/ticotsord/hosts

3. For Versions of Solaris[TM] later than 7, check the /etc/inet/ipnodes file and edit it appropriately.

4. If you changing IP addresses because the host has moved to a different subnet you may also need to amend the following files.

• /etc/inet/netmasks [netmasks(4)]

• /etc/defaultrouter [defaultrouter(4)]

• /etc/resolv.conf [resolv.conf(4)]

5. Reboot the system.

Product
Solaris 9 Operating System
Solaris 8 Operating System
Solaris 7 Operating System
Solaris 10 Operating System