How to Clear Fault from ilom CLI

CLI(Command Line Interface)

▼ View Faults Using the CLI
Before You Begin
※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※
※To clear faults in ILOM,the Admin (a) role must be enabled and the server SPor
※CMM must have ILOMfirmware 3.0.3 or later installed.
※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※※

Follow these steps to view and clear faults using the ILOMCLI.
1. Log in to the ILOM SP CLI or the CMM CLI.
2. To view a list of components that have been faulted, type:
■ From a server:
 

  ->show/SP/faultmgmt
■ From the CMM:
   ->show/CMM/faultmgmt
3. To display fault messages in the ILOM event log, type:
■ From the server:
   ->show/SP/logs/event/list
■ From the CMM:
   ->show/CMM/logs/event/list
4. Fix or replace the faulted component.

▼ Clear Faults Using the CLI

5. To clear a fault on a component, type the followingcommand:
   ->setcomponent_path clear_fault_action=true
Are you sure you want to clear component_path (y/n)? y
Set ’clear_fault_action’ to ’true
Where component_path is one of the following faultedcomponents:
    ■ Processor
    ■ Memory
    ■ Motherboard
    ■ Fan Module
    ■ Power Supply
    ■ CMM
    ■ NEM
    ■ PCI car
For example, to clear a processor fault, you would type thefollowing
   ->set /SYS/MB/P0clear_fault_action=true
Are you sure you want to clear /SYS/MB/P0 (y/