本文介绍如何在Linux系统中为eth0网卡配置两个不同的IP地址，并通过具体实例展示了正确的配置方法及验证配置成功的命令。
配置 /etc/conf.d/net
#把 eth0 绑定2个ip:
config_eth0=("192.168.1.102 netmask 255.255.255.0" "192.168.2.102 netmask 255.255.255.0")
查看命令：
# ip addr
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast qlen 1000
link/ether 00:e0:4c:78:3e:40 brd ff:ff:ff:ff:ff:ff
inet 192.168.1.102/24 brd 192.168.1.255 scope global eth0
inet 192.168.2.102/24 brd 192.168.2.255 scope global eth0
inet6 fe80::2e0:4cff:fe78:3e40/64 scope link
valid_lft forever preferred_lft forever
#把 eth0 绑定2个ip:
config_eth0=("192.168.1.102 netmask 255.255.255.0" "192.168.2.102 netmask 255.255.255.0")
查看命令：
# ip addr
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast qlen 1000 link/ether 00:e0:4c:78:3e:40 brd ff:ff:ff:ff:ff:ff inet 192.168.1.102/24 brd 192.168.1.255 scope global eth0 inet 192.168.2.102/24 brd 192.168.2.255 scope global eth0 inet6 fe80::2e0:4cff:fe78:3e40/64 scope link valid_lft forever preferred_lft forever
扫一扫
1281
被折叠的 条评论
为什么被折叠?
到【灌水乐园】发言
