websphere 如何安装到window7

According to IBM, to install IBM WebSphere Application Server Version 6.1 on Windows 7 or Windows Server 2008 R2, you might encounter error message from the InstallShield Wizard.

Because IBM SDK Version 1.5, which was bundled with WebSphere Application Server Version 6.1 in 2006, does not properly recognize the Windows 7 and Windows Server 2008 R2  OS. The installer is unable to run in graphical mode.

You can use the built-in Administrator account on the Windows Server 2008 R2 OS to install the application server using the launchpad application. Before using the launchpad application, you must configure the install.exe files to use the proper Windows application compatibility mode.

To install the application server in the graphical mode on the Windows Server 2008 R2 os.
you need to complete the following steps:

         1. Right-click Properties on the install.exe file with the WAS folder of the installation image for WebSphere Application Server Version 6.1. The Properties window displays.

         2. Click the Compatibility tab on the Properties window.

         3. Click Change settings for all users on the Compatibility tab. A new Properties window displays.

         4. Select the Run the program in compatibility mode option for Windows Server 2008 (Service Pack 1) mode.  you must select the Windows Server 2008 (Service Pack 1) mode when you are using the Windows Server 2008 R2 operating system.

         5. Click OK at the bottom of the window and click OK on the remaining window.

         6. Run the install.exe file to install the application server.

Note: A system prereq-check failure windows displays during the installation process. The failure message occurs for any operating system that was released after the 2006 introduction of WebSphere Application Server Version 6.1. You can ignore that failure message and continue.

 

---------------------------------------

 

解决：?

???????????? -console?   ????????  -silent  ??????????

问题