CISCO路由器的用户级别

最新推荐文章于 2024-09-04 17:39:58 发布

gotonet

最新推荐文章于 2024-09-04 17:39:58 发布

阅读量1k

点赞数

CC 4.0 BY-SA版权

分类专栏： cisco 文章标签： cisco 路由器 command system output less

本文链接：https://blog.youkuaiyun.com/gotonet/article/details/1355452

cisco 专栏收录该内容

122 篇文章

订阅专栏

本文介绍如何在路由器上设置不同级别的操作员权限，包括定义enable密码、调整命令的特权级别等，确保网络设备的安全管理和维护。

摘要生成于 C知道，由 DeepSeek-R1 满血版支持，前往体验 >

Define an Enable Password for System Operators ExamplesIn the following example, you define an enable password for privilege level 10 for system operators and make clear and debug commands available to anyone with that privilege level enabled.

enable password level 10 pswd10
privilege exec level 10 clear line
privilege exec level 10 debug ppp chap
privilege exec level 10 debug ppp error
privilege exec level 10 debug ppp negotiation

The following example lowers the privilege level of the show running-config command and most configuration commands to operator level so that the configuration can be viewed by an operator. It leaves the privilege level of the configure command at 15. Individual configuration commands are displayed in the show running-config output only if the privilege level for a command has been lowered to 10. Users are allowed to see only those commands that have a privilege level less than or equal to their current privilege level.

enable password level 15 pswd15
privilege exec level 15 configure
enable password level 10 pswd10
privilege exec level 10 show running-config

Disable a Privilege Level Example
In the following example, the show ip route command is set to privilege level 15. To keep all show ip and show commands from also being set to privilege level 15, these commands are specified to be privilege level 1.

privilege exec level 15 show ip route
privilege exec level 1 show ip
privilege exec level 1 show