linux vmware 虚拟机网络连接状态

最新推荐文章于 2025-04-16 09:00:51 发布

原创最新推荐文章于 2025-04-16 09:00:51 发布 · 2.3k 阅读

CC 4.0 BY-SA版权

在Linux系统中，VMware虚拟机遇到了无法连接到虚拟网络的问题，具体表现为Ethernet0无法连接到/dev/vmnet8。通过运行`vmware-networks`命令查看帮助和状态，发现启动网络服务时出现多个失败。解决方法是使用`modprobe`命令加载vmnet模块，然后再次启动虚拟网卡服务，成功启动了所有必要的网络服务。

安装vmware 时虚拟机机网络连接状态的转换

一：在连接虚拟机网卡的时候包如下错误

Could not connect Ethernet0 to virtual network "/dev/vmnet8". More information can be found in the VMware.log file.

Failed to connect virtual device Ethernet0

在网上找了一下资料主要是因为vmware的虚拟网卡模块没有加载。

vmware 关于网络的命令

[root@pospweb ~]# vmware-networks -h
vmware-networks version: 0.1
Usage: vmware-networks [--verbose | -v] <option>
Use exactly one of these commands:
--postinstall <component-name>,<old-version>,<new-version>
--migrate-network-settings <location of settings file>
--install-host-policy [<subnet>,<dhcp=0|1>]
--uninstall-host-policy
--start
--stop
--status

Additional options:
--help | -h
--version

hehgde

start vmware虚拟网卡

[root@pospweb ~]# vmware-networks --start
Started Bridge networking on vmnet0
Failed to start DHCP service on vmnet1
Failed to enable hostonly virtual adapter on vmnet1
Failed to start DHCP service on vmnet8
Failed to start NAT service on vmnet8
Failed to enable hostonly virtual adapter on vmnet8
Started Network detection service
Failed to start some/all services

启动不起来主要是vmware虚拟网卡的模块没有加载

加载模块

[root@pospweb ~]# modprobe vmnet

启动虚拟网卡
[root@pospweb ~]# vmware-networks --start
Started Bridge networking on vmnet0
Started DHCP service on vmnet1
Enabled hostonly virtual adapter on vmnet1
Started DHCP service on vmnet8
Started NAT service on vmnet8
Enabled hostonly virtual adapter on vmnet8
Started Network detection service
Started all configured services on all networks