How to Eliminate Mnesia Overload Events

If you’re using mnesia disc_copies tables and doing a lot of writes all at once, you’ve probably run into the following message

=ERROR REPORT==== 10-Dec-2008::18:07:19 ===





Mnesia(node@host): ** WARNING ** Mnesia is overloaded: {dump_log, write_threshold}

This warning event can get really annoying, especially when they start happening every second. But you can eliminate them, or at least drastically reduce their occurance.

Synchronous Writes

The first thing to do is make sure to use sync_transaction or sync_dirty. Doing synchronous writes will slow down your writes in a good way, since the functions won’t return until your record(s) have been written to the transaction log. The alternative, which is the default, is to do asynchronous writes, which can fill transaction log far faster than it gets dumped, causing the above error report.

Mnesia Application Configuration

If synchronous writes aren’t enough, the next trick is to modify 2 obscure configuration parameters. The mnesia_overload event generally occurs when the transaction log needs to be dumped, but the previous transaction log dump hasn’t finished yet. Tweaking these parameters will make the transaction log dump less often, and the disc_copies tables dump to disk more often. NOTE : these parameters must be set before mnesia is started; changing them at runtime has no effect. You can set them thru the command line or in a config file.

dc_dump_limit

This variable controls how often disc_copies tables are dumped from memory. The default value is 4, which means if the size of the log is greater than the size of table / 4, then a dump occurs. To make table dumps happen more often, increase the value. I’ve found setting this to 40 works well for my purposes.

dump_log_write_threshold

This variable defines the maximum number of writes to the transaction log before a new dump is performed. The default value is 100, so a new transaction log dump is performed after every 100 writes. If you’re doing hundreds or thousands of writes in a short period of time, then there’s no way mnesia can keep up. I set this value to 50000, which is a huge increase, but I have enough RAM to handle it. If you’re worried that this high value means the transaction log will rarely get dumped when there’s very few writes occuring, there’s also a dump_log_time_threshold configuration variable, which by default dumps the log every 3 minutes.

How it Works

I might be wrong on the theory since I didn’t actually write or design mnesia, but here’s my understanding of what’s happening. Each mnesia activity is recorded to a single transaction log. This transaction log then gets dumped to table logs, which in turn are dumped to the table file on disk. By increasing the dump_log_write_threshold, transaction log dumps happen much less often, giving each dump more time to complete before the next dump is triggered. And increasing dc_dump_limit helps ensure that the table log is also dumped to disk before the next transaction dump occurs.

 

以上转自：http://streamhacker.com/2008/12/10/how-to-eliminate-mnesia-overload-events/

 

经本人试验，可通过在启动 mnesia 时候进行相关参数的设置，具体命令如下：

p { margin-bottom: 0.21cm; }

erl -mnesia dump_log_write_threshold 50000 -mnesia dc_dump_limit 40