2440上的LCD驱动移植

嵌入式Linux之我行，主要讲述和总结了本人在学习嵌入式linux中的每个步骤。一为总结经验，二希望能给想入门嵌入式Linux的朋友提供方便。如有错误之处，谢请指正。

• 共享资源，欢迎转载： http://hbhuanggang.cublog.cn

一、移植环境

• 主  机：VMWare--Fedora 9
• 开发板：Mini2440--64MB Nand
• 编译器：arm-linux-gcc-4.3.2

二、移植步骤

1. 修改内核源码。2.6.30.4内核对LCD的支持已很完善，这里只做少许修改

#gedit arch/arm/mach-s3c2440/mach-smdk2440.c

   修改smdk2440_lcd_cfg函数和smdk2440_fb_info函数，设置LCD参数，我的是NEC3.5寸TFT屏。如下：

   打开LCD的背光，如不打开就无法观测LCD是否正常工作。由开发板原理图可以看到LCD的背光电源LCD_PWR接到S3C2440的GPG4引脚上，故作如下修改

2. 配置内核选项。选上LCD支持和Logo图标

Device Drivers --->     Graphics support --->         < > Lowlevel video output switch controls         <*> Support for frame buffer devices --->             --- Support for frame buffer devices             [*] Enable firmware EDID             [ ] Framebuffer foreign endianness support --->             [*] Enable Video Mode Handling Helpers             [ ] Enable Tile Blitting Support             *** Frame buffer hardware drivers ***             < > Epson S1D13XXX framebuffer support             <*> S3C2410 LCD framebuffer support             [ ] S3C2410 lcd debug messages             < > Silicon Motion SM501 framebuffer support             < > Virtual Frame Buffer support (ONLY FOR TESTING!)             < > E-Ink Metronome/8track controller support             < > Fujitsu MB862xx GDC support             < > E-Ink Broadsheet/Epson S1D13521 controller support         [*] Backlight & LCD device support --->             Display device support --->             Console display driver support --->         [*] Bootup logo --->             --- Bootup logo             [ ] Standard black and white Linux logo             [ ] Standard 16-color Linux logo             [*] Standard 224-color Linux logo (NEW)

3. 重新编译内核并下载到开发板上，上电系统启动后可以看到LCD亮起，并且出现小企鹅图标。