SRX210H启动信息

U-Boot 1.1.6 (Build time: Oct  9 2009 - 11:16:01)

SRX_210_VOICE board revision major:1, minor:32, serial #: AABB4315
OCTEON CN5020-SCP pass 1.1, Core clock: 400 MHz, DDR clock: 200 MHz (400 Mhz data rate)
DRAM:  1024 MB
Starting Memory POST...
Checking datalines... OK
Checking address lines... OK
Checking 512K memory for U-Boot... OK.
Running U-Boot CRC Test... OK.
Flash:  4 MB
USB:   scanning bus for devices... 3 USB Device(s) found
       scanning bus for storage devices... 1 Storage Device(s) found
Clearing DRAM........ done
BIST check passed.
Starting PCI
PCI Status: PCI 32-bit
PCI BAR 0: 0xf8000000, PCI BAR 1: Memory 0x00000000  PCI 0x00000000
Net:   octeth0
POST Passed
Press SPACE to abort autoboot in 1 seconds
ELF file is 32 bit
Loading .text @ 0x8f000078 (241008 bytes)
Loading .rodata @ 0x8f03ade8 (13908 bytes)
Loading .rodata.str1.4 @ 0x8f03e43c (15972 bytes)
Loading set_Xcommand_set @ 0x8f0422a0 (96 bytes)
Loading .rodata.cst4 @ 0x8f042300 (20 bytes)
Loading .data @ 0x8f043000 (5572 bytes)
Loading .data.rel.ro @ 0x8f0445c4 (120 bytes)
Loading .data.rel @ 0x8f04463c (136 bytes)
Clearing .bss @ 0x8f0446c8 (8304 bytes)
## Starting application at 0x8f000078 ...
Consoles: U-Boot console
Found compatible API, ver. 1.5

FreeBSD/MIPS U-Boot bootstrap loader, Revision 1.5
(builder@ormonth.juniper.net, Fri Oct  9 10:55:15 UTC 2009)
Memory: 1024MB
[0]Booting from nand-flash slice 1
Un-Protected 1 sectors
writing to flash...
Protected 1 sectors
Loading /boot/defaults/loader.conf
/kernel data=0x93f85c+0xc73c0 syms=[0x4+0x76200+0x4+0xa7754]

Hit [Enter] to boot immediately, or space bar for command prompt.
Booting [/kernel]...
Kernel entry at 0x801000d8 ...
getbootinfo: magic 0x0 md 0x80c26000 memsize 0x0
getbootinfo: boothowto 0x1000 kernend 0x80d00000 memsize 1024MB kernelname /kernel

Platform Starting
init regular console
Initializing octeon watchdog
GDB: debug ports: uart
GDB: current port: uart
KDB: debugger backends: ddb gdb
KDB: current backend: ddb
getmemsize: msgbufp[size=32768] = 0x8000cfe4
Copyright (c) 1996-2010, Juniper Networks, Inc.
All rights reserved.
Copyright (c) 1992-2006 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
        The Regents of the University of California. All rights reserved.
JUNOS 10.1R2.8 #0: 2010-05-11 05:02:14 UTC
    builder@queth.juniper.net:/volume/build/junos/10.1/release/10.1R2.8/obj-octeon/bsd/sys/compile/JSRXNLE
JUNOS 10.1R2.8 #0: 2010-05-11 05:02:14 UTC
    builder@queth.juniper.net:/volume/build/junos/10.1/release/10.1R2.8/obj-octeon/bsd/sys/compile/JSRXNLE
real memory  = 1073741824 (1024MB)
avail memory = 535977984 (511MB)
cpuid: 0, btlb_cpumap:0xffffffff
FreeBSD/SMP: Multiprocessor System Detected: 2 CPUs
Initializing watchdog interupt

Loading RT Fifo module.....
Loaded RT Fifo module
pmap_helper loaded (interface version 6, syscall 210)
cpu0 on motherboard
: CAVIUM's Octeon CPU Rev. 0.1 with no FPU implemented
        L1 Cache: I size 32kb(128 line), D size 8kb(128 line), sixty four way.
        L2 Cache: Size 128kb, ? way
obio0 on motherboard
uart0: <Octeon-16550 channel 0> on obio0
uart0: console (9600,n,8,1)
twsi0 on obio0
dwc0: <Synopsis DWC OTG Controller Driver> on obio0
usb0: DWC OTG Controller
Using DMA mode
Init: Port Power? op_state=1
Init: Power Port (0)
usb0: <USB Bus for DWC OTG Controller> on dwc0
usb0: USB revision 2.0
uhub0: vendor 0x0000 DWC OTG root hub, class 9/0, rev 2.00/1.00, addr 1
uhub0: 1 port with 1 removable, self powered
uhub1: vendor 0x0409 product 0x005a, class 9/0, rev 2.00/1.00, addr 2
uhub1: single transaction translator
uhub1: 3 ports with 2 removable, self powered
umass0: STMicroelectronics ST72682  High Speed Mode, rev 2.00/2.10, addr 3
pcib0: <Cavium on-chip PCI bridge> on obio0
Disabling Octeon big bar support
PCI Status: PCI 32-bit: 0xc041b
pcib0: Initialized controller
pci0: <PCI bus> on pcib0
pci0: <simple comms> at device 1.0 (no driver attached)
pci0: <serial bus, USB> at device 2.0 (no driver attached)
pci0: <serial bus, USB> at device 2.2 (no driver attached)
cpld0 on obio0
gblmem0 on obio0
octpkt0: <Octeon RGMII> on obio0
cfi0: <AMD/Fujitsu - 4MB> on obio0
platform_cookie_read not implemented
Timecounter "mips" frequency 400000000 Hz quality 0
Timecounters tick every 1.000 msec
fxp_ctrlif_attach:fxpctrldev = c1c87400
fxp2_ctrlif_attach:fxpctrldev = 0xc1c87400
Loading the NETPFE ethernet module
Loading E1/T1/J1 driver
Loading the DS1/E1 Media Layer; Attaching to media services layer
Loading common multilink module.
Loading the NETPFE PPPoE module
Loading the netpfe services driver
Loading the NETPFE docsis module
Loading the XDSL Media Layer; Attaching to media services layer
Loading the IPSec driver
 Loading the PTM driver

Loading the DIALER driver
Loading Link Services PICs module.
IPsec: Initialized Security Association Processing.
SMP: AP CPU #1 Launched!
da0 at umass-sim0 bus 0 target 0 lun 0
da0: <ST ST72682 2.10> Removable Direct Access SCSI-2 device
da0: 40.000MB/s transfers
da0: 2000MB (4096000 512 byte sectors: 255H 63S/T 254C)
if_pfe_open: listener socket opened, listening on ...
Trying to create bootdev, rootpartition da0s1a
Trying to mount root from ufs:/dev/da0s1a
Attaching /cf/packages/junos via /dev/mdctl...
Mounted junos package on /dev/md0...

Media check on da0
Automatic reboot in progress...
** /dev/da0s1a
FILE SYSTEM CLEAN; SKIPPING CHECKS
clean, 218704 free (40 frags, 27333 blocks, 0.0% fragmentation)
Verified junos signed by PackageProduction_10_1_0
veriexec: cannot update veriexec for /etc/voip/musiconhold.conf: No such file or directory
Verified jboot signed by PackageProduction_10_1_0
Verified junos-10.1R2.8-domestic signed by PackageProduction_10_1_0
** /dev/bo0s3e
FILE SYSTEM CLEAN; SKIPPING CHECKS
clean, 25092 free (12 frags, 3135 blocks, 0.0% fragmentation)
** /dev/bo0s3f
FILE SYSTEM CLEAN; SKIPPING CHECKS
clean, 312482 free (34 frags, 39056 blocks, 0.0% fragmentation)
Loading configuration ...
mgd: commit complete
Setting initial options:  debugger_on_panic=NO debugger_on_break=NO.
Starting optional daemons:  usbd.
Doing initial network setup:.
Initial interface configuration:
TNPv3: adding neighbor 0x00000001 to interface lo0.
additional daemons: eventd.
savecore: /dev/bo0s1b: No such file or directory
savecore: Reboot reason(s): 0x20: power-button soft power off
savecore: no dumps found
Additional routing options:kern.module_path: /boot//kernel;/boot/modules -> /boot//kernel;/boot/modules;/modules
.
Doing additional network setup:.
Starting final network daemons:.
setting ldconfig path: /usr/lib /opt/lib
starting standard daemons: cron.
Initial rc.mips initialization:.
Local package initialization:.
root@SRX210H%  daemons:.
root@SRX210H% el: -1 -> 1
root@SRX210H% FS partition...
root@SRX210H% ion created
Creating JAIL MFS partition...
JAIL MFS partition created
Boot media /dev/da0 has dual root support
root@SRX210H%
root@SRX210H% EAN; SKIPPING CHECKS
root@SRX210H% free (33 frags, 27342 blocks, 0.0% fragmentation)
Sat Nov  4 13:52:48 UTC 2000

SRX210H (ttyu0)

login: root
Password:
root@SRX210H%
--- JUNOS 10.1R2.8 built 2010-05-11 05:02:14 UTC

root@SRX210H%
root@SRX210H% cli
could not open user interface connection: management daemon not responding
Retry connection attempts ? [yes,no] (yes) yes
root@SRX210H> configure
Entering configuration mode

[edit]
root@SRX210H#