用cisco服务器添加html,inaitlab.com/configure/5019.html‘ title=‘文章标题：如何在CISCO中配置ISD网络服务器 -电脑资料...

Step 1 configure term isdn switch-type basic .net 3 dialer-list 1 protocol ip permit step 2 interface bri 0 ip address negotiated encapsulation ppp dialer string 169 dialer load-threshold 255 outbound dialer-group 1 ppp authentication chap

Step 1

configure term

isdn switch-type basic.net3

dialer-list 1 protocol ip permit

step 2

interface bri 0

ip address negotiated

encapsulation ppp

dialer string 169

dialer load-threshold 255 outbound

dialer-group 1

ppp authentication chap callin

ppp chap hostname 169

ppp chap password 169

Step 3

interface Ethernet0

ip address 192.168.1.1 255.255.255.0

ip nat inside

interface BRI0

ip nat outside

Step 4

ip nat inside source list 1 interface BRI0 overload

ip route 0.0.0.0 0.0.0.0 BRI0

aclearcase/" target="_blank" >ccess-list 1 permit 192.168.1.0 0.0.0.255

FW:有几个不懂还请帮着解释一下

isdn switch-type basic-net3 (这是中国交换机的型号？)

dialer load-threshold 255 outbound (呵呵~~~~~看不懂)

ip nat inside(为什么在以太网上用NAT，不是用在串口上映射私有地址号吗？)

interface BRI0

ip nat outside(什么意思？)

ip nat inside source list 1 interface BRI0 overload (呵呵~~~~老大，我看不懂这个了)

sdn switch-type basic-net3 (这是中国交换机的型号)

dialer load-threshold 255 outbound (采用链路)

ip nat inside(私有地址在公网上不许用(建议：看网络基础))

interface BRI0

ip nat outside(作为NAT的外部端口)

ip nat inside source list 1 interface BRI0 overload (做PAT)

dialer load-threshold 255 outbound 是百分百的带宽利用率

FW:关于dialer load-threshold

根据需要增加呼叫提高带宽

在轮换组中一个接口的值达到设定的参数时，后面的呼叫从轮换组中的接口拨出，inaitlab.com/configure/5019.html‘ title=‘文章标题：如何在CISCO中配置ISD网络服务器》(https://www.unjs.com)。说白了就是设置一个负载值让路由器在需要的时候拨第2个B通道

原文转自：http://www.ltesting.net