BizTalk Error: The published message could not be routed

最新推荐文章于 2024-12-04 11:59:40 发布

转载最新推荐文章于 2024-12-04 11:59:40 发布 · 275 阅读

本文介绍了BizTalkServer中消息无法路由的问题及其解决方案。主要分析了可能的原因，包括未绑定或启动编排、端口未注册及启动、消息属性未被提升等，并给出了相应的检查步骤。

摘要生成于 C知道，由 DeepSeek-R1 满血版支持，前往体验 >

BizTalk Error: The published message could not be routed<?xml:namespace prefix = o ns = "urn:schemas-microsoft-com:office:office" />

Error details: The published message could not be routed because no subscribers were found. This error occurs if the subscribing orchestration or send port has not been enlisted, or if some of the message properties necessary for subscription evaluation have not been promoted.

Resolution:

You would try the following options.

1. Your orchestration is bound, enlisted and started

2. Your ports are enlisted and started

3. You have promoted all the message variables that are used in the orchestration logic

4. The type that is promoted in the incoming message matches the type of the message in the receive shape.

5. You are not using the passthrough receive pipeline, because that does not promote the message type of the message, and therefore routing is impossible.

You can get more detail information on how to diagnose the routing failures in BizTalk Server 2006 from the article below.

Diagnosing Routing Failures in BizTalk Server 2006

http://www.winterdom.com/weblog/2006/03/16/DiagnosingRoutingFailuresInBizTalkServer2006.aspx

Reference:

1. http://www.chwlund.com/?p=97