hpux中Cluster lock的作用

最新推荐文章于 2023-05-29 11:17:33 发布

weixin_33962621

最新推荐文章于 2023-05-29 11:17:33 发布

阅读量155

点赞数

CC 4.0 BY-SA版权

原文链接：http://www.cnblogs.com/ddr888/archive/2009/06/18/1506111.html

本文详细介绍了集群锁（ClusterLock）的概念及其配置方法。集群锁作为连接中断器，在集群发生故障时，防止两个节点同时尝试重建集群。文章推荐了在不同规模的集群中使用集群锁的情况，并说明了如何通过IRST_CLUSTER_LOCK_VG和IRST_CLUSTER_LOCK_PV参数定义磁盘锁。

摘要生成于 C知道，由 DeepSeek-R1 满血版支持，前往体验 >

集群锁（Cluster Lock）：

集群锁是作为连接中断器（tie breaker）存在的。在下列情况下起作用，当运行的集群出错时，两个节点都试图重建一个新集群。集群锁可以被配置为磁盘锁或者仲裁服务器。你可以用两者的任意一个作为集群锁，但是不能在同一集群中同时使用。在配置集群是要考虑一下情况，对于两个节点的集群，必须使用集群锁；对于三个或四个节点的集群，强烈建议使用集群锁；对于多于四个节点的集群，建议使用集群锁。如果决定对多于四个节点的集群配置一个集群锁，它必须是仲裁服务器。

可以用IRST_CLUSTER_LOCK_VG 和 FIRST_CLUSTER_LOCK_PV参数来定义集群锁。IRST_CLUSTER_LOCK_VG表示LVM卷组承载集群锁，这个卷组不能同时在其他集群中作为集群锁存在。

*************************寂寞分割线********************

# Cluster Lock Parameters
# The cluster lock is used as a tie-breaker for situations
# in which a running cluster fails, and then two equal-sized
# sub-clusters are both trying to form a new cluster. The
# cluster lock may be configured using either a lock disk
# or a quorum server.

# You can use either the quorum server or the lock disk as
# a cluster lock but not both in the same cluster.
# Consider the following when configuring a cluster.
# For a two-node cluster, you must use a cluster lock. For
# a cluster of three or four nodes, a cluster lock is strongly
# recommended. For a cluster of more than four nodes, a
# cluster lock is recommended. If you decide to configure
# a lock for a cluster of more than four nodes, it must be
# a quorum server.

# Lock Disk Parameters. Use the FIRST_CLUSTER_LOCK_VG and
# FIRST_CLUSTER_LOCK_PV parameters to define a lock disk.
# The FIRST_CLUSTER_LOCK_VG is the LVM volume group that
# holds the cluster lock. This volume group should not be
# used by any other cluster as a cluster lock device.

转载于:https://www.cnblogs.com/ddr888/archive/2009/06/18/1506111.html