virsh default启动失败原因分析及解决

最新推荐文章于 2024-06-21 15:16:14 发布

weixin_30266829

最新推荐文章于 2024-06-21 15:16:14 发布

阅读量3.1k

点赞数

CC 4.0 BY-SA版权

文章标签： php

原文链接：http://www.cnblogs.com/goooogs/p/3664734.html

本文讨论了在使用virt-manager设置虚拟机连接时遇到的网络地址冲突问题，详细介绍了如何通过更改地址设置来解决Error starting network: Internal error Network is already in use by interface eth0错误，确保虚拟机网络启动正常。

摘要生成于 C知道，由 DeepSeek-R1 满血版支持，前往体验 >

启动default时出现如下错误提示：
[root@node1 ~]# virsh net-start default
error: Failed to start network default
error: internal error Network is already in use by interface eth0

提示信息表明，default所在的网段被eth0占用。
网上查寻结果表明，问题出在eth0的配置上。
检查eth0配置，发现之前添加的eth0:0网段与default网段冲突。删除eth0:0配置文件，重启网络，再次启动default，成功。

" I finally figured it out. The solution was actually quite simple. In virt-manager when you setup a connection it asks for the network address. The address I had previously setup for eth0 was xxx.xxx.xxx.64/26. I used this same one for the virt-manager connection. Obviously, this is why I was getting the error "Error starting network: Internal error Network is already in use by interface eth0".

To fix it, in virt-manager i just used xxx.xxx.xxx.64/27, giving the connection a different block of addresses. This solved the problem entirely. I can't believe it was that simple."
(参考: http://ubuntuforums.org/showthread.php?t=1789126)

转载于:https://www.cnblogs.com/goooogs/p/3664734.html