连Linux的ftp报错10054,FTP 10054 错误解决方法

THE INFORMATION IN THIS ARTICLE APPLIES TO:

CuteFTP® Home (All Versions)

CuteFTP Pro® (All Versions)

SYMPTOMS

During an FTP session, the following error is encountered:

ERROR:> Can't read from

control socket. Socket error = #10054.

CAUSE & RESOLUTION

A socket error 10054 may be the result of the remote server or some

other piece of network equipment forcibly closing or resetting the

connection. In some other situations a change to the default

CuteFTP connection settings may be needed for connections to this

particular remote FTP server.

The most common cause for a socket

error 10054 is the use of an invalid FTP host address. Double-check

to make sure that you are using the correct FTP host address.

Before making any changes to the

default configuration for CuteFTP, wait and retry your connection

later. A socket error 10054 can also be caused by any of the

following reasons:

The remote server was stopped or

restarted.

The remote network interface is

disabled for some reason.

There are too many users logged on to

the server.

Your account on the remote server is

restricted for some reason.

If this error started happening after

a recent upgrade to your Web browser, (for example, after upgrading

to Internet Explorer 7.0) please browse

to

If you are satisfied that the remote

server or user account is not at fault, and you encountered this

error either when first establishing the connection or when

starting a file transfer, then it may be necessary to change the

data connection type. CuteFTP uses passive (PASV)

mode by default but for this remote server you may need to use

active (PORT) mode instead.

To make the switch

from PASV mode

to PORT mode in

CuteFTP Home, open the Site

Manager and click once on the the name of

the problem site on the left side of the window. On

the Type tab

change the Data Connection

Type to Use

Port.

If you are using CuteFTP

Professional, in the Site

Manager, right-click on the name of the problem site and

click Site Properties. On

theType tab, change

the Data Connection

Type to Use

Port.

Note: If changing the data connection

type has no effect then you should return this setting to the

default of Use global

settings.

In some other situations, the remote

FTP server may have difficulty dealing with some of the more

advanced capabilities used by the default configuration of CuteFTP

Professional. In such situations,

If the solutions provided above do

not resolve this problem then it is possible that the transfer send

and receive buffer size may be set too high. See the resolution

provided in KB Article ID

10293 for further instructions.

1.无效的ftp地址。