联发科MT2502模块平台上的iSink说明-优快云博客

本文详细介绍了MT2502平台上的iSink控制机制，包括ISINK0和ISINK1的配置流程，如何设置电流步进、工作模式及启用状态，为开发者提供了实用的代码示例。

摘要生成于 C知道，由 DeepSeek-R1 满血版支持，前往体验 >

[MTK软件经验分享] [FAQ12570][Power]MT2502平台上的iSink说明

在MT2502平台上，有一个ISINK物理输出的路由，它的输出电流是最大的。96mA在软件中，配置了两条iSink路由：ISINK 0和ISINK 1，最大值，每个电流为48mA。
有关iSink控件，请参阅下面：
DCL_HANDLE handle;
PMU_CTRL_ISINK_SET_EN isink_en;
PMU_CTRL_ISINK_SET_STEP isinkCtrl;
PMU_CTRL_ISINK_SET_MODE isinkCtrlMode;

handle = DclPMU_Open(DCL_PMU, FLAGS_NONE);

//isinks to set pwm/register mode
isinkCtrlMode.isink = ISINKS;
isinkCtrlMode.mode = ISINK_REGISTER_CTRL_MODE;
DclPMU_Control(handle, ISINK_SET_MODE, (DCL_CTRL_DATA_T *)&isinkCtrlMode);

资料下载地址：http://bbs.16rd.com/citiao-xinpian-mt2502.html
//isink 0
isinkCtrl.isink = ISINK0;
isinkCtrl.step = ISINK0_STEP;
DclPMU_Control(handle, ISINK_SET_STEP, (DCL_CTRL_DATA_T *)&isinkCtrl)

//isink 1
isinkCtrl.isink = ISINK1;
isinkCtrl.step = ISINK1_STEP;
DclPMU_Control(handle, ISINK_SET_STEP, (DCL_CTRL_DATA_T *)&isinkCtrl)

// ISINK0
isink_en.isink = ISINK0;
isink_en.enable = ISINK0_EN;

DclPMU_Control(handle, ISINK_SET_EN, (DCL_CTRL_DATA_T *)&isink_en);
// ISINK1
isink_en.isink = ISINK1;
isink_en.enable = ISINK1_EN;
DclPMU_Control(handle, ISINK_SET_EN, (DCL_CTRL_DATA_T *)&isink_en)

DclPMU_Close(handle);