Chapter 4-17. Troubleshooting Congestion in Fibre Channel Fabrics

Link failure Link reset failed due to timeout

Example 4-23 shows this message. It indicates that the interface transmitted a LR primitive but did not receive a LRR back within 100ms. This is likely due to the interface being at zero remaining-Tx-B2B-credits for an extended time (1 or 1.5 seconds). Hence, it initiates Credit Loss Recovery by transmitting an LR. Since LR is transmitted during normal link initialization it could also be a non-congestion problem during link activation. Under normal situations, this should exactly correlate to instances of Credit Loss Recovery by LR. If the neighbor is also an MDS it may not have returned the LRR due to severe ingress congestion. If so, see the earlier Syslog message indicating ‘Link failure Link Reset failed nonempty recv queue’. 4-23 显示了这条信息。它表明接口传输了 LR 原始信息,但在 100ms 内没有收到 LRR 返回。这可能是由于接口在较长时间(1 1.5 秒)内剩余 Tx-B2B 信用点为零。因此,它会通过传输 LR 来启动信用损失恢复。由于 LR 是在正常链路初始化期间传输的,因此也可能是链路激活期间的非拥塞问题。在正常情况下,这应与通过 LR 恢复信用损失的实例完全相关。如果邻居也是 MDS,它可能因入口严重拥塞而没有返回 LRR。如果是这样,请参阅之前的系统日志消息,其中显示 "链路故障 链路重置失败 非空重置队列"

Example 4-23 System message - Link failure Link reset failed due to timeout

%PORT-5-IF_DOWN_LINK_FAILURE: %$VSAN 200%$ Interface fc1/30 is down (Link failure

Link reset failed due to timeout)

Refer to Chapter 3, the section on Link Failure — Link Reset Failed Nonempty Recv Queue (LR Rcvd B2B) for more details. 有关详细信息,请参阅第 3 "链路故障 - 链路重置失败非空重发队列 (LR Rcvd B2B)"

评论
添加红包

请填写红包祝福语或标题

红包个数最小为10个

红包金额最低5元

当前余额3.43前往充值 >
需支付:10.00
成就一亿技术人!
领取后你会自动成为博主和红包主的粉丝 规则
hope_wisdom
发出的红包

打赏作者

mounter625

你的鼓励将是我创作的最大动力

¥1 ¥2 ¥4 ¥6 ¥10 ¥20
扫码支付:¥1
获取中
扫码支付

您的余额不足,请更换扫码支付或充值

打赏作者

实付
使用余额支付
点击重新获取
扫码支付
钱包余额 0

抵扣说明:

1.余额是钱包充值的虚拟货币,按照1:1的比例进行支付金额的抵扣。
2.余额无法直接购买下载,可以购买VIP、付费专栏及课程。

余额充值