本文介绍如何使用YUM安装GCC、PCRE及ZLIB等依赖，并通过wget下载Tengine源码包进行编译安装。此外还详细说明了Nginx服务的启动、停止及设置开机自启的方法。
yum install gcc-c++
yum install pcre pcre-devel
yum install zlib zlib-devel
yum install openssl openssl-devel
wget http://tengine.taobao.org/download/tengine-2.2.0.tar.gz
tar -vxf tengine-2.2.0.tar.gz
./configure --prefix=/usr/local/nginx
make & make install
启动/usr/local/nginx/sbin/nginx
=======================================
设置开机启动
cd /usr/lib/systemd/system
vim nginx.service
chmod 745 nginx.service
启动服务
systemctl start nginx.service
停止服务
systemctl stop nginx.service
设置为开机启动
systemctl enable nginx.service
停止开机自启动
systemctl disable nginx.service
yum install pcre pcre-devel
yum install zlib zlib-devel
yum install openssl openssl-devel
wget http://tengine.taobao.org/download/tengine-2.2.0.tar.gz
tar -vxf tengine-2.2.0.tar.gz
./configure --prefix=/usr/local/nginx
make & make install
启动/usr/local/nginx/sbin/nginx
=======================================
设置开机启动
cd /usr/lib/systemd/system
vim nginx.service
chmod 745 nginx.service
启动服务
systemctl start nginx.service
停止服务
systemctl stop nginx.service
设置为开机启动
systemctl enable nginx.service
停止开机自启动
systemctl disable nginx.service
扫一扫
751
被折叠的 条评论
为什么被折叠?
到【灌水乐园】发言
