1. Start Spork in a terminal window.
2. Write a single test or small group of tests.
3. Run Command-Shift-R to verify that the test or test group is red.
4. Write the corresponding application code.
5. Run Command-Shift-E to run the same test/group again, verifying that it’s green.
6. Repeat steps 2–5 as necessary.
7. When reaching a natural stopping point (such as before a commit), run rspec
spec/ at the command line to confirm that the entire test suite is still green.
2. Write a single test or small group of tests.
3. Run Command-Shift-R to verify that the test or test group is red.
4. Write the corresponding application code.
5. Run Command-Shift-E to run the same test/group again, verifying that it’s green.
6. Repeat steps 2–5 as necessary.
7. When reaching a natural stopping point (such as before a commit), run rspec
spec/ at the command line to confirm that the entire test suite is still green.
扫一扫
332
被折叠的 条评论
为什么被折叠?
到【灌水乐园】发言
