How to Install and Configure a VNC Server on RedHat Enterprise Linux (RHEL) 6

最新推荐文章于 2023-10-09 13:25:05 发布

jjw97_5

最新推荐文章于 2023-10-09 13:25:05 发布

阅读量988

点赞数

分类专栏： Linux/Unix

Linux/Unix 专栏收录该内容

18 篇文章

订阅专栏

本文提供在Red Hat Enterprise Linux 6上安装和配置VNC服务器的详细步骤，包括软件安装、设置用户密码、配置分辨率、启动服务及防火墙配置。

http://www.dell.com/support/article/us/en/19/SLN283098/EN

Article Summary: This article provides information on how to install and configure a VNC server on RedHat Enterprise Linux (RHEL) 6.

1. Installation of the software

Ensure you are logged in as 'root'
If you have connectivity to RHN or a Satellite Server :
- # yum install tigervnc-server
If you do not have connectivity to RHN or a Satellite Server :
Create a local 'yum' repository
More information : How to Create a Local 'yum' Repository in RedHat Enterprise Linux (RHEL) 5 and 6

2. Configure VNC password for the user(s)

Switch user to the user you want to use for VNC :
- # su - vncuser1

NOTE: Replace 'vncuser1' with the correct username

Set the VNC password for the user :
$ vncpasswd
$ exit
Repeat for each VNC user as necessary

3. Configure resolution for the user(s)

Edit '/etc/sysconfig/vncservers' with your favorite editor
Append the following lines :
- VNCSERVERS="1:vncuser1 2:vncuser2"
- VNCSERVERARGS[1]="-geometry 1024x768"
- VNCSERVERARGS[2]="-geometry 1024x768"

NOTE: Replace 'vncuser1' and 'vncuser2' with the correct usernames. You can add more users as needed. In addition, you can change the resolution value as needed.

4. Start the VNC server

Start the service :
- # service vncserver start
Ensure service is started on reboots :
# chkconfig vncserver on

5. Configure the firewall

# iptables -I INPUT -m state --state NEW -p tcp --destination-port 5901 -j ACCEPT
# iptables -I INPUT -m state --state NEW -p tcp --destination-port 5902 -j ACCEPT

NOTE : Each user requires an additional firewall port opened starting at 5901. Because we added two users above, we need to open two ports.