Linux下Mount第二块硬盘

Step #1: Following command will list all detected hard disks:
# fdisk -l | grep '^Disk'
Output:

Disk /dev/sda: 251.0 GB, 251000193024 bytes
Disk /dev/sdb: 251.0 GB, 251000193024 bytesA device name refers to the entire hard disk. For more information see Linux partition naming convention and IDE drive mappings.

To partition the disk - /dev/sdb, enter:
# fdisk /dev/sdb
The basic fdisk commands you need are:
m - print help
p - print the partition table
n - create a new partition
d - delete a partition
q - quit without saving changes
w - write the new partition table and exit

Step#2 : Format the new disk using mkfs.ext3 command
To format Linux partitions using ext2fs on the new disk:
# mkfs.ext3 /dev/sdb1

Step#3 : Mount the new disk using mount command
First create a mount point /disk1 and use mount command to mount /dev/sdb1, enter:
# mkdir /disk2
# mount /dev/sdb1 /disk2
# df -H

Step#4 : Update /etc/fstab file
Open /etc/fstab file, enter:
# vi /etc/fstab
Append as follows:
/dev/sdb1 /disk2 ext3 defaults 1 2 Save and close the file.

Task: Label the partition
You can label the partition using e2label. For example, if you want to label the new partition /backup, enter
# e2label /dev/sdb1 /backup

You can use label name insted of partition name to mount disk using /etc/fstab:
LABEL=/backup /disk1 ext3 defaults 1 2

LABEL=/backup /disk2 ext3 defaults 1 2
+----------------------------------------------------------------------------------------------------------------------------+