[Solved] There is no currnt hw_target (Cannot connect to Zybo-z7 board by Vivado) under Ubuntu 16.04

最新推荐文章于 2025-04-24 10:16:46 发布

Jeremy_ku

最新推荐文章于 2025-04-24 10:16:46 发布

阅读量598

点赞数 1

CC 4.0 BY-SA版权

分类专栏： FPGA 文章标签： Jtag UART Zybo Vivado UART-USB

本文链接：https://blog.youkuaiyun.com/haifeng_gu/article/details/86501492

在Ubuntu 16.04上使用Vivado 2016.4时遇到了无法通过Jtag连接Zybo-z7开发板的问题。问题出在没有在正确目录下运行。解决方法是进入包含文件的目录并运行，确保设备已连接并开机。最终成功连接并能对Zybo-z7-20板卡进行编程。注意未找到文件，故未调整其权限。

摘要生成于 C知道，由 DeepSeek-R1 满血版支持，前往体验 >

OS: Ubuntu 16.04 LTS
Vivado version: 2016.4

I installed Vivado under /home/user/…/ folder rather than the default /opt/…/ folder.
It’s mainly because the problems of access permission.

I tried to execute the following command with root permission using sudo rather than went to the deepest directory. It did not work.
Don't work with sudo permission
That is because ./install_digilent.sh should be called under correct directory where the install_digilent.sh file is.