本文提供了解决npf驱动未在常规计算机管理WMI接口可见的问题的方法，包括使用cmd.exe作为管理员运行scqcnpf命令检查npf状态，并激活或自动启动npf服务。
The npf driver is not visible in your regular "Computer Management" WMI-interface. The npf status is best checked with the command line.
Run a cmd.exe as administrator and run the command sc qc npf.
You should get some output like this:
C:\Windows\system32>sc qc npf
[SC] QueryServiceConfig SUCCESS
SERVICE_NAME: npf
TYPE : 1 KERNEL_DRIVER
START_TYPE : 2 AUTO_START
ERROR_CONTROL : 1 NORMAL
BINARY_PATH_NAME : system32\drivers\npf.sys
LOAD_ORDER_GROUP :
TAG : 0
DISPLAY_NAME : NetGroup Packet Filter Driver
DEPENDENCIES :
SERVICE_START_NAME :
If your driver is not properly started, activate it with the command sc start npf
Finally, to start the service automatically, use the command sc config npf start=auto
Remember to run your cmd.exe as administrator when issuing these command.
Run a cmd.exe as administrator and run the command sc qc npf.
You should get some output like this:
C:\Windows\system32>sc qc npf
[SC] QueryServiceConfig SUCCESS
SERVICE_NAME: npf
TYPE : 1 KERNEL_DRIVER
START_TYPE : 2 AUTO_START
ERROR_CONTROL : 1 NORMAL
BINARY_PATH_NAME : system32\drivers\npf.sys
LOAD_ORDER_GROUP :
TAG : 0
DISPLAY_NAME : NetGroup Packet Filter Driver
DEPENDENCIES :
SERVICE_START_NAME :
If your driver is not properly started, activate it with the command sc start npf
Finally, to start the service automatically, use the command sc config npf start=auto
Remember to run your cmd.exe as administrator when issuing these command.
扫一扫
863
被折叠的 条评论
为什么被折叠?
到【灌水乐园】发言
