from
http://www-1.ibm.com/support/docview.wss?uid=swg21105430
这2天在WAS设置全局安全性,试来试去,试的启动不了了,这下傻眼了。
1、把“活动用户注册表”设置成“本地OS”,
2、同时在“本地 OS 用户注册表 ”中输入的服务器用户标识和密码是对应操作系统的登录用户名和密码的。
如果更改了操作系统的登录密码,那么必须在重启WAS控制台之前把第2步中输入的密码同时进行修改,否则下次启动时会出现安全认证问题。
万一没改就重启了,那就参考IBM的这篇FAQ在不启动控制台的情况下修改security.xml文件。有2种方式:
这2天在WAS设置全局安全性,试来试去,试的启动不了了,这下傻眼了。
1、把“活动用户注册表”设置成“本地OS”,
2、同时在“本地 OS 用户注册表 ”中输入的服务器用户标识和密码是对应操作系统的登录用户名和密码的。
如果更改了操作系统的登录密码,那么必须在重启WAS控制台之前把第2步中输入的密码同时进行修改,否则下次启动时会出现安全认证问题。
万一没改就重启了,那就参考IBM的这篇FAQ在不启动控制台的情况下修改security.xml文件。有2种方式:

Technote (FAQ) |
|
Problem |
If the administrative server is running, you can use either the administrative console or the wsadmin tool to disable security. However, if you cannot start the administrative server, you must use wsadmin to disable security. This technote explains the procedure. |
|
|
|
Solution |
Occasionally when WebSphere® global security is enabled and you need to be disable it, you cannot start the administrative Application Server or deployment manager. This situation can occur when the administrative server does not start due to a problem with the security configuration. In this case, you are locked out of the administrative console, and you cannot use it to disable security; therefore, you must use a wsadmin command to disable security. Solution You can disable security by modifying the security.xml file or by using wsadmin. The security.xml file is located under install_root/config/cells/cellname. Always store a copy of the security.xml file in a temporary directory before making any changes. To disable security in security.xml:
|
来自 “ ITPUB博客 ” ,链接:http://blog.itpub.net/69355/viewspace-112678/,如需转载,请注明出处,否则将追究法律责任。
转载于:http://blog.itpub.net/69355/viewspace-112678/