hacmp无法查看clstat

AIX6中clstat问题解决

最新推荐文章于 2024-08-30 15:05:58 发布

转载最新推荐文章于 2024-08-30 15:05:58 发布 · 375 阅读

本文介绍了解决AIX6操作系统下clstatorcldump无法启动的问题。通过在snmpdv3.conf文件中启用特定的MIB子树（1.3.6.1.4.1.2.3.1.2.1.5），可以确保clstat功能正常运行。文章提供了两种启用方法，并说明了重启snmp守护进程的步骤。

操作系统是aix6，而ha的版本是hacmp5.X，不是powerHA。

不能查看clstat。最后我在hacmp目录里面，看到redeme update文件里面有完整的解决方法。

APAR IZ41204: Enabling Internet MIB tree for clstat or cldump to work

clstat or cldump will not start if the internet MIB tree is not
enabled in snmpdv3.conf file. This behavior. is usually seen in
AIX 6.1 onwards where this internet MIB entry was intentionally
disabled as a security issue. This internet MIB entry is required to
view/resolve risc6000clsmuxpd (1.3.6.1.4.1.2.3.1.2.1.5) MIB sub tree
which is used by clstat or cldump functionality.

There are two ways to enable this MIB sub tree(risc6000clsmuxpd) they
are:
1) Enable the main internet MIB entry by adding this line in
/etc/snmpdv3.conf file
VACM_VIEW defaultView internet - included -
But doing so is not advisable as it unlocks the entire MIB tree

2) Enable only the MIB sub tree for risc6000clsmuxpd without enabling
the main MIB tree by adding this line in /etc/snmpdv3.conf file
VACM_VIEW defaultView 1.3.6.1.4.1.2.3.1.2.1.5 - included -

Note: After enabling the MIB entry above snmp daemon must be restarted
with the following commands as shown below:
1) stopsrc -s snmpd
2) startsrc -s snmpd
After snmp is restarted leave the daemon running for about two minutes
before attempting to start clstat or cldump.

来自 “ ITPUB博客 ” ，链接：http://blog.itpub.net/13337857/viewspace-692934/，如需转载，请注明出处，否则将追究法律责任。

转载于:http://blog.itpub.net/13337857/viewspace-692934/