1.思科设备:
show interfaces fc1/1 transceiver
2.华为设备:
Dis transceiver interface GigabitEthernet 0/0/49
3.华三设备:
display transceiver diagnosis interface 查看所有光口光功率
Transceiver Type 光模块类型。
Connector Type 接口类型。
Wavelength(nm) 光波波长。
Transfer Distance(m) 光波传输距离。50um或62.5um表示光纤直径,光纤为多模光纤。当光纤直径为9um时表示单模光纤。
Digital Diagnostic Monitoring 光模块诊断信息是否监控。
Vendor Name 光模块制造厂商名称。
Vendor Part Number 厂家部件编码。
Ordering Name 光模块对外型号。
Manu. Serial Number 光模块生产序列号。
Manufacturing Date 光模块生产日期。
Temperature(°C) 光模块当前温度。
Temp High Threshold(°C) 光模块温度上限。
Temp Low Threshold(°C) 光模块温度下限。
Voltage(V) 光模块当前电压。
Bias Current(mA) 光模块当前电流。
Bias High Threshold(mA) 光模块电流上限。
Bias Low Threshold(mA) 光模块电流下限。
RX Power(dBM) 光模块接收功率。当接收功率为0瓦时,显示为-Inf。
RX Power High Threshold(dBM) 光模块接收功率上限。
RX Power low Threshold(dBM) 光模块接收功率下限。
TX Power(dBM) 光模块发送功率。当发送功率为0瓦时,显示为-Inf。
TX Power High Threshold(dBM) 光模块发送功率上限。
TX Power Low Threshold(dBM) 光模块发送功率下限。
下面附光口信息8G、16G、32G
MDS9718# show int fc1/1 tran
fc1/1 sfp is present
Name is CISCO-FINISAR
Manufacturer's part number is FTLF8529P3BCV-CS
Revision is A
Serial number is FNS22260PB8
Cisco part number is 10-2666-01
Cisco pid is DS-SFP-FC16G-SW
FC Transmitter type is short wave laser w/o OFC (SN)
FC Transmitter supports short distance link length
Transmission medium is multimode laser with 62.5 um aperture (M6)
Supported speeds are - Min speed: 4000 Mb/s, Max speed: 16000 Mb/s
Nominal bit rate is 14000 Mb/s
Link length supported for 50/125um OM2 fiber is 35 m
Link length supported for 62.5/125um fiber is 15 m
Link length supported for 50/125um OM3 fiber is 100 m
Cisco extended id is unknown (0x0)
No tx fault, no rx loss, in sync state, diagnostic monitoring type is 0x68
SFP Diagnostics Information:
Temperature : 30.62 C
Voltage : 3.37 V
Current : 8.11 mA
Optical Tx Power : -2.56 dBm
Optical Rx Power : -2.55 dBm
Tx Fault count : 0
Note: ++ high-alarm; + high-warning; -- low-alarm; -low-warning
MDS9718# show int fc1/48 tran
fc1/48 sfp is present
Name is CISCO-AVAGO
Manufacturer's part number is SFBR-57G5MZ-CS1
Revision is V03
Serial number is AVD2215W1RK
Cisco part number is 10-3206-01
Cisco pid is DS-SFP-FC32G-SW
FC Transmitter type is short wave laser w/o OFC (SN)
FC Transmitter supports short distance link length
Transmission medium is multimode laser with 50 um aperture (M5)
Supported speeds are - Min speed: 8000 Mb/s, Max speed: 32000 Mb/s
Nominal bit rate is 28000 Mb/s
Link length supported for 50/125um OM3 fiber is 70 m
Cisco extended id is unknown (0x0)
No tx fault, no rx loss, in sync state, diagnostic monitoring type is 0x68
SFP Diagnostics Information:
Temperature : 32.75 C
Voltage : 3.34 V
Current : 7.50 mA
Optical Tx Power : 0.26 dBm
Optical Rx Power : -0.87 dBm
Tx Fault count : 0
Note: ++ high-alarm; + high-warning; -- low-alarm; -low-warning
MDS9148S# show int fc1/1 tran
fc1/1 sfp is present
Name is CISCO-FINISAR
Manufacturer's part number is FTLF8529P3BCV-CS
Revision is A
Serial number is FNS240902VK
Cisco part number is 10-2666-01
Cisco pid is DS-SFP-FC16G-SW
FC Transmitter type is short wave laser w/o OFC (SN)
FC Transmitter supports short distance link length
Transmission medium is multimode laser with 62.5 um aperture (M6)
Supported speeds are - Min speed: 4000 Mb/s, Max speed: 16000 Mb/s
Nominal bit rate is 14000 Mb/s
Link length supported for 50/125um OM2 fiber is 35 m
Link length supported for 62.5/125um fiber is 15 m
Link length supported for 50/125um OM3 fiber is 100 m
Cisco extended id is unknown (0x0)
No tx fault, no rx loss, in sync state, diagnostic monitoring type is 0x68
SFP Diagnostics Information:
Temperature : 43.00 C
Voltage : 3.30 V
Current : 8.18 mA
Optical Tx Power : -3.02 dBm
Optical Rx Power : -3.66 dBm
Tx Fault count : 0
Note: ++ high-alarm; + high-warning; -- low-alarm; -low-warning
MDS9513# show int fc1/1 tran
fc1/1 sfp is present
Name is CISCO-AVAGO
Manufacturer's part number is SFBR-5780APZ-CS2
Revision is G2.3
Serial number is AGD16128681
Cisco part number is 10-2418-01
Cisco pid is DS-SFP-FC8G-SW
FC Transmitter type is short wave laser w/o OFC (SN)
FC Transmitter supports short distance link length
Transmission medium is multimode laser with 62.5 um aperture (M6)
Supported speeds are - Min speed: 2000 Mb/s, Max speed: 8000 Mb/s
Nominal bit rate is 8500 Mb/s
Link length supported for 50/125um OM2 fiber is 50 m
Link length supported for 62.5/125um fiber is 21 m
Link length supported for 50/125um OM3 fiber is 150 m
Cisco extended id is unknown (0x0)
No tx fault, no rx loss, in sync state, diagnostic monitoring type is 0x68
SFP Diagnostics Information:
Temperature : 39.27 C
Voltage : 3.35 V
Current : 7.25 mA
Optical Tx Power : -2.48 dBm
Optical Rx Power : -2.65 dBm
Tx Fault count : 0
Note: ++ high-alarm; + high-warning; -- low-alarm; -low-warning