eNSP多生成树协议步骤

最新推荐文章于 2024-11-21 00:08:59 发布

原创

最新推荐文章于 2024-11-21 00:08:59 发布 · 4.4k 阅读

12 ·

CC 4.0 BY-SA版权

文章标签：

#交换机

本文档详细介绍了如何在华为交换机SW1、SW2和SW3上配置多生成树协议（MSTP），包括配置VLAN、设置接口属性、启用MSTP并指定根桥，以实现网络的冗余和负载均衡。同时，路由器R1配置了接口IP地址以连接不同的VLAN。

在这里插入图片描述
SW1:
undo terminal monitor
Info: Current terminal monitor is off.
sys
Enter system view, return user view with Ctrl+Z.
[Huawei]sys SW1
[SW1]user-interface console 0
[SW1-ui-console0]idle-timeout 0 0
[SW1-ui-console0]q
[SW1]vlan bat 10 20
Info: This operation may take a few seconds. Please wait for a moment…done.
[SW1]int e0/0/1
[SW1-Ethernet0/0/1]port hybrid pvid vlan 10
[SW1-Ethernet0/0/1]port hybrid untagged vlan 10 20
[SW1-Ethernet0/0/1]int g0/0/2
[SW1-GigabitEthernet0/0/2]port link-type trunk
[SW1-GigabitEthernet0/0/2]port trunk allow-pass vlan all
[SW1-GigabitEthernet0/0/2]int g0/0/1
[SW1-GigabitEthernet0/0/1]port hybrid pvid vlan 10
[SW1-GigabitEthernet0/0/1]port hybrid untagged vlan 10 20
[SW1-GigabitEthernet0/0/1]q
[SW1]stp mode mstp
[SW1]stp region-configuration
[SW