虚拟机上网配置

VMware HostOnly 虚拟机上网配置
--------------

1
主机: Windows
虚拟机: RedHat4 AS

2
主机通过小区宽带上网. 小区宽带做了IP/MAC绑定限制.

3
Host Only

[STEP]
VMware | 编辑 | 虚拟网络编辑器
配置为HOST ONLY,[b]一定要是VM1[/b], DHCP可不开启.
其它不用的网络删除.
[img]http://dl2.iteye.com/upload/attachment/0089/8783/da468847-7e3c-337d-99e2-87082a6e4cb3.jpg[/img]

检查IP网段,这个IP作为虚拟机的网关IP.
[img]http://dl2.iteye.com/upload/attachment/0089/8785/9bf3d42a-91b2-3a59-b69f-9ab83053e831.jpg[/img]

虚拟机HOST ONLY正常情况是不能连接外网的, 若要连接外网, 拔号连接必须开共享,并且选择目标为VM1.
[img]http://dl2.iteye.com/upload/attachment/0089/8787/a864bc8d-37ff-3f4a-b5c4-db6ab2aa4f52.jpg[/img]

选择HOST ONLY.
[img]http://dl2.iteye.com/upload/attachment/0089/8789/7e3d3377-8f8c-323c-afe5-631a55dbc24c.jpg[/img]

配置IP,主要配置IP与网关.
# cat /etc/sysconfig/network-scripts/ifcfg-eth0
DEVICE=eth0
BOOTPROTO=none
HWADDR=00:0C:29:FC:4C:AF
ONBOOT=yes
TYPE=Ethernet
NETMASK=255.255.255.0
[b]IPADDR=192.168.1.200[/b]
USERCTL=no
PEERDNS=yes
[b]GATEWAY=192.168.1.1[/b]
IPV6INIT=no
#

配置DNS
# cat /etc/resolv.conf
; generated by /sbin/dhclient-script
[b]nameserver 8.8.8.8
nameserver 8.8.8.4[/b]
#

重启网络
# /etc/init.d/network restart
Shutting down interface eth0: [ OK ]
Shutting down loopback interface: [ OK ]
Setting network parameters: [ OK ]
Bringing up loopback interface: [ OK ]
Bringing up interface eth0: [ OK ]
#

断开拔号,重新连接

测试连接
# ping 8.8.8.8
PING 8.8.8.8 (8.8.8.8) 56(84) bytes of data.
64 bytes from 8.8.8.8: icmp_seq=1 ttl=47 time=13.6 ms
64 bytes from 8.8.8.8: icmp_seq=2 ttl=47 time=13.6 ms

--- 8.8.8.8 ping statistics ---
3 packets transmitted, 2 received, 33% packet loss, time 2001ms
rtt min/avg/max/mdev = 13.684/13.684/13.684/0.000 ms, pipe 2
#


最后记得关掉或设置虚拟机和本地机的防火墙!
OK!