eNSP之Telnet配置

eNSP之Telnet配置

实验环境

实验需求

1、SW1使用密码认证，SW2上使用AAA认证。
2、设置同一的管理VLAN为100，用于远程等登陆时使用，其中SW1IP为

实验配置

SW1配置

<Huawei>undo terminal monitor	//关闭设备终端信息提示
<Huawei>system-view
[Huawei]sysname SW1
[SW1]vlan 100
[SW1-vlan100]quit
[SW1]interface Vlanif 100
[SW1-Vlanif100]ip add 192.168.100.1 24
[SW1-Vlanif100]quit
[SW1]int g0/0/1
[SW1-GigabitEthernet0/0/1]port link-type trunk
[SW1-GigabitEthernet0/0/1]port trunk pvid vlan 100
[SW1-GigabitEthernet0/0/1]port trunk allow-pass vlan all
[SW1-GigabitEthernet0/0/1]quit
[SW1]

[SW1]user-interface vty 0 4	//进入虚拟用户终端接口
[SW1-ui-vty0]authentication-mode password 	//设置认证模式为密码认证
[SW1-ui-vty0]set authentication password cipher huawei	//设置密码为密文格式的“huawei”
[SW1-ui-vty0]user privilege level 3	//设置用户权限等级为3
[SW1-ui-vty0]quit[SW1]int g0/0/1
[SW1-GigabitEthernet0/0/1]port link-type trunk
[SW1-GigabitEthernet0/0/1]port trunk pvid vlan 100
[SW1-GigabitEthernet0/0/1]port trunk allow-pass vlan all
[SW1-GigabitEthernet0/0/1]quit
[SW1]

SW2配置

<Huawei>undo terminal monitor //关闭设备终端信息提示
<Huawei>system-view
[Huawei]sysname SW2
[SW2]vlan 100
[SW2-vlan100]quit
[SW2]int vlan 100
[SW2-Vlanif100]ip add 192.168.100.2 24
[SW2-Vlanif100]quit
[SW2]int g0/0/1
[SW2-GigabitEthernet0/0/1]port link-type trunk
[SW2-GigabitEthernet0/0/1]port trunk pvid vlan 100
[SW2-GigabitEthernet0/0/1]port trunk allow-pass vlan all
[SW2-GigabitEthernet0/0/1]quit
[SW2]

[SW2]user-interface vty 0 4
[SW2-ui-vty0-4]authentication-mode aaa
[SW2-ui-vty0-4]user privilege level 3
[SW2-ui-vty0-4]quit
[SW2]aaa
[SW2-aaa]local-user huawei password cipher hcie privilege level 3
[SW2-aaa]local-user huawei service-type telnet
[SW2-aaa]quit
[SW2]

实验验证

SW1 Telnet To SW2

SW2 Telnet To SW1

下一篇我们将介绍如何使用物理机Telnet到eNSP中的网络设备