IT6122: MIPI to LVDS Converter

The IT6122 is a high-performance and low-power MIPI to LVDS converter, fully compliant with MIPI D-PHY 1.1, DSI 1.1 and LVDS specifications. 
IT6122是一款高性能低功耗MIPI到LVDS转换器,完全符合MIPI D-PHY 1.1, DSI 1.1和LVDS规范。

The IT6122 supports four lanes MIPI RX and 2-Link LVDS TX interface. 
IT6122支持四通道MIPI RX和2链路LVDS TX接口。

The data transfer rate of MIPI RX is up to 1 Gbps per lane and the LVDS TX supports as high as 1.05 Gbps per channel.
MIPI RX每通道的数据传输速率高达1gbps, LVDS TX每通道的数据传输速率高达1.05 Gbps。

IT6122 support MIPI DSI packed pixel stream 24-bit RGB888, loosely packed pixel stream 18-bit RGB666 and packed pixel stream 18-bit RGB666 mode, the sync even short packets can be received and generate HSync and VSync by firmware setting. 
IT6122支持MIPI DSI封装像素流24位RGB888、松散封装像素流18位RGB666和封装像素流18位RGB666模式,同步甚至可以接收短数据包,通过固件设置生成HSync和VSync。

A Pattern Generator is embedded in the IT6122 and thus the video data and timing can be easily switched from ext

在 FPGA 程序中编写 MIPI (Mobile Industry Processor Interface) 到 LVDS (Low-Voltage Differential Signaling) 的转换器测试代码通常涉及到硬件描述语言如 VHDL 或 Verilog,以及相应的 Xilinx 或 Intel FPGA SDK。这里是一个简单的示例,假设我们正在使用Xilinx ISE工具: ```vhdl library IEEE; use IEEE.STD_LOGIC_1164.ALL; entity mipi_to_lvds_converter is Port ( mipi_data : in std_logic_vector(31 downto 0); -- MIPI数据输入 mipi_clk : in std_logic; -- MIPI时钟输入 lvds_tx_out : out std_logic_vector(1 downto 0); -- LVDS输出 reset_n : in std_logic -- 清零信号 ); end entity mipi_to_lvds_converter; architecture Behavioral of mipi_to_lvds_converter is begin process(mipi_clk, reset_n) variable temp_data : std_logic_vector(1 downto 0); begin if rising_edge(mipi_clk) and reset_n = '0' then temp_data <= "00"; -- 初始化LVDS数据 elsif rising_edge(mipi_clk) after 1 ns then -- 数据处理延迟 case mipi_data(7 downto 5) is when "000" => temp_data <= mipi_data(31 downto 28); -- ...其他映射规则 when others => temp_data <= "xxxx"; -- 未定义模式,填充默认值 end case; lvds_tx_out <= temp_data; -- 更新LVDS输出 end if; end process; end architecture Behavioral; ``` 在这个例子中,我们创建了一个实体和架构,它接收MIPI数据、时钟和清零信号,然后基于MIPI数据的不同字段将数据映射到LVDS输出上。这是一个简化的版本,实际设计可能需要考虑更多细节,比如差分信号编码、同步等问题。
评论
成就一亿技术人!
拼手气红包6.0元
还能输入1000个字符
 
红包 添加红包
表情包 插入表情
 条评论被折叠 查看
添加红包

请填写红包祝福语或标题

红包个数最小为10个

红包金额最低5元

当前余额3.43前往充值 >
需支付:10.00
成就一亿技术人!
领取后你会自动成为博主和红包主的粉丝 规则
hope_wisdom
发出的红包
实付
使用余额支付
点击重新获取
扫码支付
钱包余额 0

抵扣说明:

1.余额是钱包充值的虚拟货币,按照1:1的比例进行支付金额的抵扣。
2.余额无法直接购买下载,可以购买VIP、付费专栏及课程。

余额充值